CVE-2026-10674
Published:July 21, 2026
Updated:August 06, 2026
The NXP LPUART serial driver (drivers/serial/uart_mcux_lpuart.c), when CONFIG_UART_USE_RUNTIME_CONFIGURE is enabled, called LPUART_Deinit() at the start of mcux_lpuart_configure(), which disables the LPUART peripheral clocks. The requested configuration is validated only afterwards (in mcux_lpuart_configure_basic), and unsupported parity/data-bit/stop-bit/flow-control values return -ENOTSUP before the clock is re-enabled.
As a result, a uart_configure() request with an unsupported configuration left the LPUART in a clock-disabled state; any subsequent access to LPUART registers (poll_out/poll_in, interrupt handling, or a later reconfigure) faults on the gated peripheral and escalates to a hard fault, crashing the system.
uart_configure() is a Zephyr syscall whose verifier (z_vrfy_uart_configure) only checks that cfg is readable user memory and forwards the caller-supplied configuration unchanged, so an unprivileged userspace thread with access to an LPUART device can deterministically trigger the fault, a persistent system-wide denial of service.
Introduced in v2.5.0 and present in all subsequent releases until this fix, which removes the LPUART_Deinit() call and instead only disables the transmitter/receiver, leaving the clock running.
Related Resources (5)
Do you need more information?
Contact UsCVSS v4
Base Score:
6.8
Attack Vector
LOCAL
Attack Complexity
LOW
Attack Requirements
NONE
Privileges Required
LOW
User Interaction
NONE
Vulnerable System Confidentiality
NONE
Vulnerable System Integrity
NONE
Vulnerable System Availability
HIGH
Subsequent System Confidentiality
NONE
Subsequent System Integrity
NONE
Subsequent System Availability
NONE
CVSS v3
Base Score:
5.5
Attack Vector
LOCAL
Attack Complexity
LOW
Privileges Required
LOW
User Interaction
NONE
Scope
UNCHANGED
Confidentiality
NONE
Integrity
NONE
Availability
HIGH
Weakness Type (CWE)
Reachable Assertion
EPSS
Base Score:
0.11